The bow is the finishing touch to the gift wrapping. It can be of different colors, different configurations, but it should always be done neatly and effectively. Take the trouble, and you will receive an enthusiastic smile of your loved one for whom you have prepared a gift.
Instructions
Step 1
The easiest way is to tie a ribbon in the shape of a terry flower. Such a bow will look more elegant from a hard material. Take the ribbon and fold it into several rings equal to the diameter of the future bow. Then smooth out the hinges and make diagonal cuts. Roll the loops again so that the cut triangles are in the center of the folded strips of fabric.
Step 2
Then tighten the slits tightly with the tape and straighten all the loops in turn, starting with the inner ones, alternately turning one to the right and the other to the left. Fluff up the bow and it's done.
Step 3
A two-color bow will look original on a single-color package. Take one wide and one narrow tape in different shades. Form a loop of a wide tape, and glue the ends together. Then do the same with the narrow tape overlaid on top. Smooth the resulting structure tightly and fix the inside with a paper clip in the center. The final form of the Bantu will be given by the third ribbon, which should be long enough to tie it to the gift.
Step 4
You can try to create a tiered bow. To do this, take already three ribbons of different width and color. Make the narrowest cut the shortest and cut the widest one longer. Form the ends of a bow and tie all folded pieces together with a fourth ribbon. Again, leave long ends for securing to the gift box.
Step 5
It will not be difficult to make a bow flower. To do this, take the tape and, holding it with your thumb and forefinger, make a ring. Wind the tape until you have about a dozen of these rings. Tie the rings with a long ribbon, straighten the loops one by one and secure this flower to the gift.
Step 6
The chrysanthemum bow will look very original on the gift wrapping. It is much easier to make it than it might seem at first glance. The beginning of work repeats the manufacture of a terry flower. Only after fastening the ribbons with a wire at the place of the cut, give them the appearance of chrysanthemum petals. To do this, make even cuts on the folded hinges. After that, straighten the petals, turning the loops to the left and to the right. Start with the inner sides - first with one, then with the other.
