A simple Easter egg can become an original gift, an exclusive interior decoration. A full-fledged egg is not suitable for participating in interior design, it requires skills to preserve the shell from the shell, which, as a result, should remain from the egg.
It is necessary
- - a needle - 1 piece;
- - plaster - 10 cm;
- - raw egg - 1 pc.
Instructions
Step 1
Take a raw egg, rinse it gently with detergent in running water. Wipe the egg with a terry towel or leave to dry on its own.
Step 2
Take a saucer where the egg white and yolk will drain. Take the needle carefully, it can be either very thin or with a large diameter. An ordinary awl is also suitable for piercing the shell. Pick up an egg. On the tapered side of the egg, make a hole with a needle, repeat the same procedure on the opposite side of the egg, making the hole slightly larger than the previous one.
Step 3
Place your lips over the opening and slowly blow out the liquid into the saucer prepared for this. If the hole is too small, then the blowing process will take a long time. In this case, simply take the needle again and widen the holes in the shell on both sides.
Step 4
When all the contents of the egg are in the plate, rinse the inside of the egg with a thin stream of water or with a syringe filled with water. Rinse the shells until you are convinced that the inside is clean and the possibility of microorganisms multiplying there is negligible. After rinsing, leave the shells to dry for a few hours. And from the remaining eggs on the plate, you can make an omelet, scrambled eggs or a cosmetic mask.
Step 5
Once the eggshell is dry, take the plaster, cut 4 identical strips and glue two tightly on each hole. Glue the patch crosswise so that air and paint cannot get into the hole. And the basis for crafts is ready!
