When preparing for the wedding ceremony, as a rule, a lot of attention is paid to the wedding cortege. High-quality car decoration is a rather difficult task that requires certain skills and adaptations. Therefore, it is recommended to trust it to professionals. However, if you are confident in your abilities and are not afraid to experiment, you can try decorating the car yourself.
It is necessary
- - tapes;
- - threads;
- - a needle;
- - rubber;
- - braid.
Instructions
Step 1
Ribbons Ribbons are perhaps the most popular decoration for a wedding car. Traditionally, an odd number of colored stripes are placed next to each other, on one of the sides of the trunk and hood. For these purposes, you can use cotton, satin or nylon ribbons. In order to securely fix the jewelry on the car, you must carefully measure the car in the place where you plan to fix it. Multiply the measured result by 1, 5 and purchase tapes of the appropriate size.
Step 2
There are at least two simple and reliable ways to secure your jewelry. Finish the edges of the stripes and sew the elastic to one side of the elastic. Pull the tape over the trunk or hood of your car and secure the free end of the elastic to the other end of the tape using thread and a needle. It should be remembered that it is impractical to sew the elastic to both ends at once, since you simply cannot put the tape on the car - the loops with which the hood and trunk are attached will interfere. An alternative method of fastening is to use a tape. Gently sew three ribbons of the chosen color together. Sew the tape to the ends of the resulting strip. Place the ribbons over the hood and tie the braid tight.
Step 3
An additional decoration can be “roses made of ribbons in a contrasting color. To make such a “flower, you need to take a strip of one meter long. Step back 15 cm from the edge and wrap the fabric around your palm. Leave a free end with a length of 20 cm. Pull it through the resulting rings and connect to the other end, tying a knot. Secure to the previously tensioned tapes using the ends left.
Step 4
BalloonsBalloons are the most inexpensive and, at the same time, effective material for decorating wedding processions. It is recommended to use quality latex balloons from well-known manufacturers, as Chinese counterparts may burst during movement. Inflate the balloons and tie them to antennas, door handles and car rear-view mirrors. Garlands of balls can be used to decorate the trunk and hood. Make sure that jewelry will not get in the way of the driver while driving.
